Points Credit : 4,900 points Currently valued at US$65
- The kit works against New-G plastic-assembled-frame #FPI-ABS-NGF1-060which has accompanied with the product already ;
- The inner frame is capable for sustaining for the resin-made bodyweight firmly ;
- Users may re-tighten the screws at the joints of the inner frameby using household screwdriver whenever necessary ;
- The complete fundamental mode of the RX-105 is demonstrableindependently ;
- The eyes are installed with LED which is powered by a rechargeablebattery located inside the rear hip. The DC jet is hidden up by an openablecover part.
- The tail stabilizers are movable upwards and downwards againsta POM-made gear-spring mechanism. The mechanism is capable to sustain theweight of the tail stabilizers to avoid uncontrolled falling problem.
Product codes : GS-274
Overall height : 42.3 cm
Head height : 34.5 cm
Shoulder width : 30.8 cm
Overall depth : 38.5 cm ( when the tail stabilizer has been stretched over )
Kit weight : 2.9 kgs
Part A - No. of W1 “Main-White” resin parts : 140 pcs.
Part B - No. of B6 “Navy-Blue” resin parts : 44 pcs.
Part C - No. of G3 “Heavy-Grey” resin parts : 51 pcs.
Part D - No. of ABS made V-Antenna in yellow color : 1 pc.
Part E - No. of G2 “Medium-Grey” resin parts : 33 pcs.
Part F - No. of Y3 “Orange-Yellow” resin parts : 46 pcs.
Part G - No. of R2 “Custom-Red” resin parts : 25 pcs.
Part H - No. of G5 “Blue-Grey” resin parts : 37 pcs.
Part I - No. of ABS cast parts : 5 pcs.
Part EP - Silver coated copper-made pins : 27 pcs.
Part SW - No. of screws of various standards: 14 pcs.
Part SP - No. of springs : 2 pcs. ( Ø5mm x 10mm )
Part AA - No. of alluminium made mini parts : 29 pcs.
Part LD – LED system x 1 set
Part NG – Plastic Injection made, pre-assembled New-G Robot internal frame #FPI-ABS-NGF1-060 x 1 box
Part PO – No. of POM injection made parts : 4 pcs.
Part HP – No. of heat pressed clear parts : 6 pcs.
Part CR – No. of clear resin parts : 1 pc.
Part MP - No. of dark-iron coated metal thrusters : 5 pcs ( Ø20mm x 20mm )
Part PE - No. of photo-etch : 5 pcs ( 2 main designs + 3 for metal thrusters )
Part MA - No. of magnets : 4 pcs. ( Ø3mm x 2mm )
Part CP - No. of copper rod : 2 pcs. ( Ø3mm x 100 mm + Ø2mm x 120 mm)
Part DE - No. of water slide decal : 1 pcs.
No. of 4R photos : 3 pcs.